Jump to content

Featured Replies

Mal i do agree with you. I have been using Oracal oramask810 for the past years and it sure does work fine too. I usually jump between the two when i run out of either!

What are the differences or advantages of Artool over Oramask 810 (my usual choice) Mal?

I love Oramask 810, but the pre-shrunk issue with heat and time is a real bummer. Not a huge deal, as there are ways around it, but just have to be careful about how/when/where the masks are cut, and should be able to get around the issue. 

I agree with the OP; Artool Ultramask is the best I've used.

  • 1 month later...

Can anyone recommend a good US suppliers for the Uktramask?

  • 2 weeks later...
On 9/22/2020 at 11:57 AM, RadBaron said:

Can anyone recommend a good US suppliers for the Uktramask?

It looks like coastairbrush.com carries Ultra Mask.

 

I've only purchased one time from them, airbrush part, but had no problems.

 

Dave

 

  • 3 weeks later...
On 10/6/2020 at 1:13 PM, denders said:

It looks like coastairbrush.com carries Ultra Mask.

 

I've only purchased one time from them, airbrush part, but had no problems.

 

Dave

 

Thanks mate, I'll have a look!

  • 3 weeks later...

I see Coast Airbrush has Artool Hobby Mask too. Anyone ever try that?

To answer my question about Artool Hobby Mask, it is adhesive backed clear material only, there is not carrier to be able to use it in a cutter. (I purchased some.) It is probably just fine for masking canopies.

dixie art is a  a bit less expensive then  coastairbrush  btw I have used both of them in the past  

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...