dashotgun

made my own will post them up

as stated above needed

View File ferensi 1/32 mustang combination of traced and designed scaled for 1/32 revell but would work for tamiya as well see my national insignia as well. the upper two C and 5 are slightyly larger as seen on the aircraft and meant to painted white the square on the bottom is for the natural metal area on the port side where the info decal goes. two ferensi mask are provided as the aircraft was only photographed from the port side begging the question of if it had it on the starboard side as well Submitter dashotgun Submitted 02/14/2021 Category Specific Aircraft  

usaf mustang stars View File these are for revell mustang but could be used for the tamiya traced off off of the cutting edge decals for Fernesi Submitter dashotgun Submitted 02/14/2021 Category U.S. - WW2  

well it would be a series of very small boxes so not lines

can't get the sizes for 1/32 or how to weld it thanks. ushci makes a set but would rather diy

yes the autoblade is back ordered everywhere.

hm the new basic lets you import jpgs and others now, have you tried using type faces? there are a lot of ttf which are usaf din raf etc

what do you use as a transfer tape?

i now have both and agree with the above I ordered 810 and received the 813. the store told me to keep it and sent the proper 810. I have used the 813 it will stand up to typical enamel point solvent but it is useful where you are only applying to a flat surface. I use montex masks and sure enough that is 810. FWIW there is a steep learning curve with the included software

it is for a cricut but fits cameo and it supposed to be better at small intricate cuts

View File mud splatter useful on both aircraft or vehicles hope this is useful Submitter dashotgun Submitted 12/07/2020 Category Vehicles - AFVs & Military  

these were not my masks they predated my cameo except for the ac id numbers they came from montex. I did make the stripe mask as well, The model is almost done it has been ignored for a about 1.5 years sadly. I did lose the direction finding antenna after the pictures were done. Trumpeter is not very good about replacing parts so I made the mount via sculpy clay and the antenna will be from strip styrene or a some scap PE.

agree with above the tracing does not always work well but he letters can be d/l as fonts or are already here on the site

fw 190 exhaust trim View File this is the white flash around the black exhaust trim seen on many FW 190 traced from the cutting edge decal sheet originally in 1/32 will need to be resized to your purpose Submitter dashotgun Submitted 11/29/2020 Category Camouflage Patterns  

I just got the 810 they promised me it is thinner and more supple then the 813 I think the 810 conforms better.

good to know it does seem thicker as well

I have used the role holder it worked fine but as stated I think given that we are cutting small masks rather then large projects seems better to just use the matt and small pieces. I just asked a question about the 813. do you use water color paint as the 810 is suggested for solvent type paints. I ended up ordering 810 but they sent 813 they are going to send me some 810 so now will have both.