WoodyV Posted April 18, 2022 Share Posted April 18, 2022 Here are the settings I use when cutting Oramask 810. NOTE: Since this picture was made I've increased the speed to 6. Perhaps it could be set at a higher speed but that's your decision. OVERCUT simply extends the corner cuts beyond the apex and guarantees the corners are sharp and the mask pieces separate completely. 5 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.