Hi Folks.
Here is my 1/32 Phantom thin wing conversion.
Be aware that there is a lot of other steps necessary to achieve a true B Phantom conversion, but this is a good start point.
For the general "how to", please refer to my topic on LSP.
Better cut the outer panel parts in 0.5mm sheet as the original wing is 1mm (assemble 2 to get the thickness) the inner detail was cut in 0.3 on my build.
Have fun, and if you happen to use this successfuly, dont hesitate to leave me a little comment on how it went.
Cheers.
Mathieu
-
2
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.