This handy article on the 3DCuts website discusses a feature introduced in v3 of the Silhouette Studio software that helps make sharp corner cuts better:

https://3dcuts.com/silhouette-line-segment-overcut-tutorial

Thanks for Leon over at LSP for posting the link!

Kev

It's come to my attention that the interface for these settings is quite different in the latest versions of the Silhouette Studio software. I'm using v5 of the software (5.0.219ssbe Business Edition), and I found them by going to the SEND area, then clicking on the MORE button in the Modify Settings area:

This opens up a long list of material types, but there's a settings panel at the bottom, which contains the settings in question:

And a couple of parameters you can adjusted when selected:

Kev

Line Segment Overcut is very useful, but be careful that you do not inadvertently clip off very small parts in tight places.

Gene K