Leaderboard

I'll echo all the good advice that's been mentioned by the more experienced folks Similar to Timbacat, I generally use oracal 810 for most items like insignia, numbers, etc and tamiya sheets for canopies there's a fair bit of technique to learn, this site is a great resource for getting started...and it's a wonderful thing when you peel that mask off leaving a great looking insignia

Thank you all for the advice, it's great !!!!!

Thumbs up here for Oramask 810, fits the bill perfectly but I’d highly recommend Cricut transfer sheets for aligning the masks accurately. The “Tamiya” tape sheets are very expensive in comparison to Oramask and I find less forgiving to cut, but that could just be me. When using Oramask for canopies’ compound curves it’s wise the make some strategically placed side cuts to help the mask to conform more easily, like these Typhoon ones: Max

I use Artool Ultra Mask, which is similar to Oramask, but some say a little less tacky. It is available on a roll or in packs of A4 sheets. I've also tried the Tamiya sheets. Plus points: The Tamiya sheets work, and have a printed grid to aid alignment. The downside is that it is not particularly transparent, which in some circumstances can make placing and alignment more difficult.